Connect Systems CS1001 Instalační manuál stáhnout pdf (Strana 9)

System Testing (continued)

6. If you are using the Alarm Abort feature, set the Alarm Panel, initiate an

alarm condition and (If the alarm system incorporates bell delay this will be

overridden) unset the alarm system within 90 seconds.

7. Contact your ARC to confirm that all signals have been received. Ensure

that all ‘Restore’ signals are received when the Dualcom input terminals

return to their quiescent value.

8. If the quiescent (non-active) states of the input terminals are incorrect, i.e.

‘positive applied/removed is inverted, then the ARC will report that the Alarm/

Restore or Open/Close is the ‘wrong way round. To correct this, on Dualcom

Mk2, use the Self Learning Input feature. See page 13.

For Dualcom Mk1, contact the ARC or the Help Desk at CSL for remote

programming.

Note : When ALARM calls are made, both PSTN & VDN paths are

activated, but only ONE alarm call will be received. This will be from

the path that is the first to send the alarm call to the ARC.

9. If at any time you wish to cancel a call, short the Reset pins. See Fig 1 & 2.

10.Remember to note the Dualcom ESN & NUA numbers (and any security

access numbers) on the site records that will be stored at your office. See

Fig 3 and page 14.

11. Your Dualcom is now fully tested.

Note: When transporting Dualcom Mk2 ALWAYS disconnect the internal

battery to stop the battery operating the Dualcom until it is discharged.

See Fig 2 and 3.

Fig 4

Internal Battery

ESN Number

(under internal

battery)

VDN Dualcom Mk2

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 49 50

Žádné komentáře

Connect Systems CS1001 Instalační manuál Strana 9